SyntheticClassBgpNeighborConfigAllOf1

Properties

boolean
allow_as_in Optional

Flag to enable allowas_in option for BGP neighbor


bfd Optional

BFD configuration for failure detection. BFD is enabled with default values when not configured.


string
graceful_restart_mode Optional

If mode is DISABLE, then graceful restart and helper modes are disabled. If mode is GR_AND_HELPER, then both graceful restart and helper modes are enabled. If mode is HELPER_ONLY, then helper mode is enabled. HELPER_ONLY mode is the ability for a BGP speaker to indicate its ability to preserve forwarding state during BGP restart. GRACEFUL_RESTART mode is the ability of a BGP speaker to advertise its restart to its peers.

Possible values are: DISABLEGR_AND_HELPERHELPER_ONLY


integer
hold_down_time Optional

Wait time in seconds before declaring peer dead.


array of string
in_route_filters Optional

Specify path of prefix-list or route map to filter routes for IN direction. This property is deprecated, use route_filtering instead. Specifying different values for both properties will result in error.


integer
keep_alive_time Optional

Interval (in seconds) between keep alive messages sent to peer.


integer
maximum_hop_limit Optional

Maximum number of hops allowed to reach BGP neighbor.


string
neighbor_address Required

Neighbor IP Address


array of string
out_route_filters Optional

Specify path of prefix-list or route map to filter routes for OUT direction. When not specified, a built-in prefix-list named ‘prefixlist-out-default’ is automatically applied. This property is deprecated, use route_filtering instead. Specifying different values for both properties will result in error.


string
password Optional

Specify password for BGP neighbor authentication. Empty string (“”) clears existing password.


string
remote_as_num Required

4 Byte ASN of the neighbor in ASPLAIN Format


route_filtering Optional

Enable address families and route filtering in each direction.


array of string
source_addresses Optional

Source addresses should belong to Tier0 external or loopback interface IP Addresses . BGP peering is formed from all these addresses. This property is mandatory when maximum_hop_limit is greater than 1.

JSON Example

{
    "neighbor_address": "string",
    "remote_as_num": "string"
}
Feedback

Was this page helpful?