Set Clusters Policies Apply
Released in v7.0.0This API will set the configured policy specification for the cluster. if you do not have all of the privileges described as follows: - Operation execution requires VcIntegrity.lifecycleSettings.Write. - The resource ClusterComputeResource referenced by the parameter cluster requires VcIntegrity.lifecycleSettings.Write.
Request
URLURL
Parameters
Parameters
Header Parameters
Header Parameters
Request Body
SettingsClustersPoliciesApplyConfiguredPolicySpec of type application/json (required){
"disable_dpm": false,
"disable_hac": false,
"enable_quick_boot": false,
"enforce_hcl_validation": false,
"evacuate_offline_vms": false,
"failure_action": {
"action": "enum",
"retry_count": 0,
"retry_delay": 0
},
"pre_remediation_power_action": "enum"
}
Disable DPM on the cluster. If unset, configured value would be unset.
Disable HA Admission control on the cluster. If unset, configured value would be unset.
Enable Quick Boot during remediation in the cluster. If unset, configured value would be unset.
Enforce Hcl validation, when applicable, to prevent remediation if hardware compatibility issues are found. If unset, hardware compatibility issues will not prevent remediation.
Evacuate powered off/suspended VMs when attempting maintenance mode. If unset, configured value would be unset.
What action is to be taken if entering maintenance mode fails on a given host of the cluster. If unset, configured value would be unset.
Specifies what should be done to the power state of the VM before entering maintenance mode. If unset, configured value would be unset.
Possible values are: